Products
   

Tilt Switch

 
Principle of Operation

The switch is hung from L/S stock pipe top. The height depends on the position at which action is desired. To enable tilting of the switch 30 cm long g1 conduit pipe is fixed on the switch, so that when the tip of the conduit pipe touches the material the switch tilts. This causes change is status i.e. Contacts changeover.

 
Material specification

Customized suiting to the service (fluid) and temperature,
Available in SS 304/ SS 316/ pp/ CS etc


     Copyrights @ Revathi Electronics & Controls. 2008 All rights reserved Website designed by Compusoft Technologies
     Site Best Viewed in 1024 x 768 Resolution, and Internet Explorer 5.0 & ABOVE